reorder
consumer-electronics.mybogy.online
ALWAYS Be Happy search home
c
Combo Blog
Categories
Play Games New
Electronics
Audio
Audio Accessories
Speaker Accessories

Monoprice Speaker Volume Controller RMS 100W (Slide Type) - White

About The monoprice.If using a single pair of speakers rated at the same load level as your amplifier, you don't need to make any changes ‑ just leave the jumper in the default x1 position.This is a slide‑type wall plate volume control for speaker systems with power ratings of up to 100 watts per channel and impedance ratings of 4 ~ 16 ohms

When setting up the speaker volume controls, it is important to match the impedance of your speaker system with the load rating of your amplifier. However, if your speakers are of a different impedance level and/or you have more than one set of speakers in parallel, please refer to the following chart as a guide for setting the jumpers on the speaker volume control.Note that for any speakers wired in series, the overall impedance level is the sum of each speaker. It can accept speaker wire in sizes from 14 ~ 22 gauge and provides a frequency response range of 35Hz ~ 20kHz (+0/‑2db) at the full power rating of 100 watts per channel.Please note: This volume control does not include a wall mounting bracket. This is a slide‑type wall plate volume control for speaker systems with power ratings of up to 100 watts per channel and impedance ratings of 4 ~ 16 ohms. Impedance Correction ChartSpeakerImpedanceAmplifierRatingJumper Setting /# of Speaker Pairsx1x2x4x84‑ohm Speakers2 ohms2 pairs4 pairs8 pairs16 pairs4 ohms1 pair2 pairs4 pairs8 pairs8 ohmsn/a1 pair2 pairs This slider control can be set to one of twelve positions, including the minimum (off) and maximum volume settings.The wall plate mounts into a standard single‑gang, low‑voltage wall bracket (not included) and has inputs and outputs for one pair of stereo speaker wires (4 input connections and 4 output connections). This is done by setting the jumpers on the volume control to compensate for the number of speakers you have in a parallel configuration and the impedance level of the speakers.If using a single pair of speakers rated at the same load level as your amplifier, you don't need to make any changes ‑ just leave the jumper in the default x1 position. So two 4‑ohm speakers wired in series is the same impedance as a single 8‑ohm speaker.

Adapters Switches & Splitters > Audio Adapters > Speaker Selectors & Volume Controllers

Monoprice Speaker Volume Controller RMS 100W (Slide Type) - White

Adapters Switches & Splitters > Audio Adapters > Speaker Selectors & Volume Controllers

Specifications of Monoprice Speaker Volume Controller RMS 100W (Slide Type) - White

CategoryElectronics > Audio > Audio Accessories > Speaker Accessories
Instockinstock

Last Updated

Monoprice Speaker Volume Controller RMS 100W (Slide Type) - White
More Varieties
Electronics
Audio
Audio Accessories

Rating :- 9.65 /10
Votes :- 16
Keystone Jack to be used with Keystone wall plates or panels.Matches white wall plates.Red plastic color code ring.Front accepts banana plugs, spades or bare wire.Keystone jacks and wall plates are used to create a cleaner, less cluttered media room when running wiring in-wall.Banana plugs and jacks are used to terminate speaker wires.Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

Keystone Jack to be used with Keystone wall plates or panels.Matches white wall plates.Red plastic color code ring.Front accepts banana plugs, spades or bare wire.Keystone jacks and wall plates are used to create a cleaner, less cluttered media room when running wiring in-wall.Banana plugs and jacks are used to terminate speaker wires.Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

govEnable GingerCannot connect to Ginger Check your internet connectionor reload the browserDisable GingerRephraseRephrase with Ginger (Ctrl+Alt+E)Edit in GingerGinger is checking your text for mistakes.Disable Ginger in this text fieldDisable Ginger on this website×.Monoprice Keystone Jack - Banana Jack w/Red Ring (Screw Type) - White For more information, go to www.ca.

  • Electronics
  • Components
  • Electronics Component Connectors
    • Keystone jack to be used with keystone wall plates or panels.Matches white wall plates.Black plastic color code ring.Front accepts banana plugs, spades or bare wire.Keystone jacks and wall plates are used when you desire to run wiring in-wall to create a cleaner, less cluttered media room.Banana plugs and jacks are used to terminate speaker wires.  *The color indicated can vary in tone and/or hue between production runs and manufacturing facilities.  The color of this item may not be an exact match to any other product, even if they are indicated as being the same color, whether sold by Monoprice or any other vendor.  Individual pieces may also vary very slightly in color from each other. Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

    Keystone jack to be used with keystone wall plates or panels.Matches white wall plates.Black plastic color code ring.Front accepts banana plugs, spades or bare wire.Keystone jacks and wall plates are used when you desire to run wiring in-wall to create a cleaner, less cluttered media room.Banana plugs and jacks are used to terminate speaker wires.  *The color indicated can vary in tone and/or hue between production runs and manufacturing facilities.  The color of this item may not be an exact match to any other product, even if they are indicated as being the same color, whether sold by Monoprice or any other vendor.  Individual pieces may also vary very slightly in color from each other. Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

    ca.gov.

  • Apparel & Accessories
  • Jewelry
  • Body Jewelry
    • The 3.5 mm plug is gold-plated for maximum conductivity and for improved resistance to corrosion over the more common tin- or nickel-plated types.

    The 3.5 mm plug is gold-plated for maximum conductivity and for improved resistance to corrosion over the more common tin- or nickel-plated types.

    The earpieces are fitted with thick, comfortable padding which improve the fit against the side of your head and helps keep outside noises from interfering with your listening pleasure.These headphones are ideal for portable applications when you want to get the best sound and really don't want to be interrupted by outside noises. They are vertically adjustable to about 1" on each side and fit close to the head.

  • Electronics
  • Audio
  • Audio Components
  • Headphones & Headsets
    • The subwoofer provides its own power and includes impedance matching circuitry, so this will not reduce the power output to the front speakers or affect the overall impedance load on the amplifier.Additionally, the subwoofer has a set of right/left Line Level inputs.

    The subwoofer provides its own power and includes impedance matching circuitry, so this will not reduce the power output to the front speakers or affect the overall impedance load on the amplifier.Additionally, the subwoofer has a set of right/left Line Level inputs.

    Please note that the manual/data sheet for this subwoofer incorrectly lists the top‑end of the crossover as having a frequency of 250Hz.75" x 11. For each input there is a corresponding output. This is an 8" powered subwoofer capable of producing 60 watts (RMS) output.

  • Vehicles & Parts
  • Vehicle Parts & Accessories
  • Motor Vehicle Electronics
  • Motor Vehicle Subwoofers
    • The subwoofer provides its own power and includes impedance matching circuitry, so this will not reduce the power output to the front speakers or affect the overall impedance load on the amplifier.Additionally, the subwoofer has a set of right/left Line Level inputs.

    The subwoofer provides its own power and includes impedance matching circuitry, so this will not reduce the power output to the front speakers or affect the overall impedance load on the amplifier.Additionally, the subwoofer has a set of right/left Line Level inputs.

    75" x 11.Please note that the manual/data sheet for this subwoofer incorrectly lists the top‑end of the crossover as having a frequency of 250Hz.1 (or greater) amplifier system. For each input there is a corresponding output.

  • Vehicles & Parts
  • Vehicle Parts & Accessories
  • Motor Vehicle Electronics
  • Motor Vehicle Subwoofers