Monoprice Dual-Source 2-Channel A/B Speaker Selector With Volume Control And Impedance Matching

Rating :- 9.31 /10

Votes :- 13

However, if your speakers are of a different impedance level and/or you have more than one set of speakers in parallel, please refer to the following chart as a guide for setting the jumpers on the speaker volume control.

Please note: This volume control does not include a wall mounting bracket. If using a single pair of speakers rated at the same load level as your amplifier, you don't need to make any changes ‑ just leave the jumper in the default x1 position. Impedance Correction Chart SpeakerImpedance AmplifierRating Jumper Setting /# of Speaker Pairs x1 x2 x4 x8 4‑ohm Speakers 2 ohms 2 pairs 4 pairs 8 pairs 16 pairs 4 ohms 1 pair 2 pairs 4 pairs 8 pairs This rotary control can be set to one of twelve positions, including the minimum (off) and maximum volume settings. This is a rotary‑type wall plate volume control for speaker systems with power ratings of up to 75 watts per channel and impedance ratings of 4 ~ 16 ohms.

However, if your speakers are of a different impedance level and/or you have more than one set of speakers in parallel, please refer to the following chart as a guide for setting the jumpers on the speaker volume control.

. When setting up the speaker volume controls, it is important to match the impedance of your speaker system with the load rating of your amplifier.This is done by setting the jumpers on the volume control to compensate for the number of speakers you have in a parallel configuration and the impedance level of the speakers. The wall plate mounts into a standard single‑gang, low‑voltage wall bracket (not included) and has inputs and outputs for one pair of stereo speaker wires (4 input connections and 4 output connections).

However, if your speakers are of a different impedance level and/or you have more than one set of speakers in parallel, please refer to the following chart as a guide for setting the jumpers on the speaker volume control.Note that for any speakers wired in series, the overall impedance level is the sum of each speaker.

When setting up the speaker volume controls, it is important to match the impedance of your speaker system with the load rating of your amplifier.

However, if your speakers are of a different impedance level and/or you have more than one set of speakers in parallel, please refer to the following chart as a guide for setting the jumpers on the speaker volume control.Note that for any speakers wired in series, the overall impedance level is the sum of each speaker.

You've set up your outdoor sound system so that you can listen to music while you relax. Wouldn't it be easier to have a volume controller out in your patio?Here's your solution: an outdoor speaker volume controller.. What a hassle it is to go all the way back inside your house just to adjust the volume.

However, if your speakers are of a different impedance level and/or you have more than one set of speakers in parallel, please refer to the following chart as a guide for setting the jumpers on the speaker volume control.Note that for any speakers wired in series, the overall impedance level is the sum of each speaker.

This is done by setting the jumpers on the volume control to compensate for the number of speakers you have in a parallel configuration and the impedance level of the speakers. A simple rotary design allows you to set your audio to the perfect listening level. Wouldn't it be easier to have a volume controller out in your patio?Here's your solution: an outdoor speaker volume controller. What a hassle it is to go all the way back inside your house just to adjust the volume.